Panel work started

Some pictures of unloading the Torana at home.

Took the passenger side door and boot to my weekly panel beating course (Boot for my mate to work on)

Here you can see the biggish dent in the passenger side door, a few others could be felt.

In this photo you can just make out the small dents on the edge and the holes on the right that need to be welded.

So far they look like this:

The big dent was pulled and beated, a quick beat was needed around the door lock and above the handle.

Need to make a plate up for the corner of the door as it's got a few rust holes.

Also a few small dents on the lower half which was hiding under filler but after that this door should be all good.

The small dents where pulled and needed a little beat, also the holes were welded up.

The boot is pretty good as does not need much more work done on it.